Notifiche
Cancella tutti
Undestanding 'Pause Print' M601. G-code implementation.
Hello,
I have been a few days with the Mini. First printer I have used. So far all has gone well with some successful prints.
I have tested 'Print Pause' in PrusaSlicer to insert hex nut. The printer head moved away to allow insertion of nut as I had hoped. However, I can not see the printer head move in the G-code.
So, is the printer head move command implemented in the firmware as part of the M601?
Phil
Postato : 17/09/2023 7:40 pm