Notifications
Clear all
Trinamic Communication Error
Any idea what might lead to this error. Print seemed to be going just fine and then stopped and displayed this error. I did have a couple of layer shifts last week but looked everything over and it all seemed to be fine. I also upgrade firmware to 4.4.1.
Napsal : 24/06/2023 12:11 am
RE: Trinamic Communication Error
I would suggest contacting Prusa Support directly. Might be a motor driver or buddy board that is going bad.
Printer: Original Prusa Mini+
Nozzles: E3D 0.25, E3D Nozzle X 0.4 , E3D 0.4, Bondtech 0.6 CHL
Printables: Tysonsw
Mastodon: [email protected]
.
Napsal : 24/06/2023 1:05 pm
RE: Trinamic Communication Error
Did you find out what the issue was? we have a mini that gives us the same error. New buddy board?
Napsal : 04/10/2023 7:06 am