Notifications
Clear all

Random beeping mid-print, no error message  

  RSS
marks
(@marks)
Active Member
Random beeping mid-print, no error message

Just got this machine set up today. A square, first layer calibration test is what I'm printing. I've done a few now, and randomly during the print the machine BEEPS VERY LOUD.

No errors on the screen or any clue as to what the problem was.

I don't see a way to attach gcode to this post, but let me know where to post it if you'd like to see it.

Firmware is the latest one, downloaded today.

Best Answer by jseyfert3:

I suspect it's not random. While you didn't post a link to the file you printed, a lot of those first layer calibrations, people tell you to adjust the Live-Z height by 0.05 or so at certain intervals. Then look at the finished piece and you have sections of different Live-Z, and find the section that looks the best.

My guess is someone added custom G-gode to the gcode file, to cause the printer to beep at the point at which they recommend you change the Live-Z height. So that while printing, when you hear the beep, dial in your Live-Z change.

This topic was modified před 2 years by marks
Napsal : 01/04/2023 12:08 am
marks
(@marks)
Active Member
Topic starter answered:
RE: Random beeping mid-print, no error message

Well, if I slice it rather than use this pre-made gcode, it's no longer doing that. Mods feel free to delete.

Napsal : 01/04/2023 12:52 am
jseyfert3
(@jseyfert3)
Reputable Member
RE: Random beeping mid-print, no error message

I suspect it's not random. While you didn't post a link to the file you printed, a lot of those first layer calibrations, people tell you to adjust the Live-Z height by 0.05 or so at certain intervals. Then look at the finished piece and you have sections of different Live-Z, and find the section that looks the best.

My guess is someone added custom G-gode to the gcode file, to cause the printer to beep at the point at which they recommend you change the Live-Z height. So that while printing, when you hear the beep, dial in your Live-Z change.

Napsal : 01/04/2023 6:45 pm
Share: