Notifications
Clear all

Prusa Mini Z binding?  

  RSS
Justin
(@justin)
Eminent Member
Prusa Mini Z binding?

My prints are definitely banding on the z axis. Not sure why after 100s of hours of prints but it started recently. I have the latest updated firmware, correct settings for my Bondtech extruder, etc.  could my Z ax is be binding? It does make a sequel at a very exact point when starting prints and the gantry moves down toward the bed but it never makes it moving up.

if it was binding how would I even fix it? it may be worth noting too that I’m use the SE mosquito but I had banding before that.   

Posted : 28/02/2021 4:38 am
Share: