Prusa Mini+ has no connection to Astroprint or Computer
Hi there,
My Prusa Mini + has not been working with astroprint since today. The Raspiberry gets no connection to the Prusa.
I played the firmware 4.3.2 on it again, but no connection. The computer displays a RASPI, but a firmware update from the computer breaks off - Nothing Found.
Any ideas ? Or is my Prusa damaged ? What can I do ?
Not sure what you mean by
The computer displays a RASPI, but a firmware update from the computer breaks off - Nothing Found.
To upgrade the firmware on the Mini, put it on the USB stick and reboot.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
RE: Prusa Mini+ has no connection to Astroprint or Computer
Hi there,
My Prusa Mini + has not been working with astroprint since today. The Raspiberry gets no connection to the Prusa.
I played the firmware 4.3.2 on it again, but no connection. The computer displays a RASPI, but a firmware update from the computer breaks off - Nothing Found.
Any ideas ? Or is my Prusa damaged ? What can I do ?
"The Raspiberry gets no connection to the Prusa."
Have you connected the Mini Micro-USB port to one of the Raspi USB ports, selected the correct interface (dev/ttyAMA0 or dev/ttyUSB0....) and baud rate? Also see here: https://help.prusa3d.com/en/article/octoprint-configuration-and-install_2182
wbr,
Karl
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.