Printing using wifi (Prusalink) and recognizing filament in sensor
I am using the newest 4.4.0 firmware. Before I was using the betas of this 4.4.0 version.
I leave my printer with filament unloaded lots of times. When I send a code to the printer using Prusalink (wether it is directly in Prusaslicer or in the web interface) the printer just start without having filament present. It probes at 170degrees and then it starts printing.
Is this problem known at Prusa?
RE: Printing using wifi (Prusalink) and recognizing filament in sensor
This is a user to user help forum. I think you're better off posting a bug report on the Prusa GitHub site to bring this issue to the attention of the developers.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
RE: Printing using wifi (Prusalink) and recognizing filament in sensor
@Rgb
Could you pls attach a short video?
even an old man can learn new things 🙂
Standard I3 mk3s, MMU2S, Prusa Enclosure, Fusion 360, PrusaSlicer, Windows 10
PRUSA MINI+ Prusalink + Prusa Connect
RE: Printing using wifi (Prusalink) and recognizing filament in sensor
@Zoltan sure.
RE: Printing using wifi (Prusalink) and recognizing filament in sensor
Somehow linking doesn't work. Lets try again:
https://forum.prusa3d.com/wp-content/uploads/2022/12/prusalink_sensor_error.mp4
RE: Printing using wifi (Prusalink) and recognizing filament in sensor
@Zoltan I also reported it on GitHub: https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/2822