Notifiche
Cancella tutti
Print head crashing into bed
For some reason my print head is crashing into my bed - it just started happening one day. I tried a full reset, no luck.
Pinda sensor is lit up and turns off when I bring metal near it. I think my Pinda sensor is the right height?
Postato : 30/10/2020 1:32 am
RE: Print head crashing into bed
It's a little hard to see from the photo, but it looks a little high, check by following the adjustment steps at the end of these instructions https://help.prusa3d.com/en/guide/how-to-replace-a-m-i-n-d-a-sensor-mini_115145 . Also check you haven't accidentally changed your live z setting.
Postato : 30/10/2020 1:17 pm