Notifiche
Cancella tutti
Nozzle/heatbreak bent? Or what's going on here?
Hi,
today I had to recalibrate my first layer i noticed something strange:
When going from left to right, the extrusion width is much higher than in die other 3 directions. It looks a bit like the nozzle is not looking straight down, but instead the tip is bent a bit to the left side? Or is there any other possibility?
Is there any way to check this (except test printing)?
I didn't touch nozzle, nor heatbreak since last calibration, right now I have no idea how this could have happened.
Postato : 16/03/2021 9:36 pm