Notifiche
Cancella tutti
New PRUSA Mini+ = Rattle sound cannot identify
Received the pre-built kit and noticed the rattling sound (almost like a high pitch tic, tic tic) when doing fast movements mostly on infills. I can’t seem to identify where this is coming from and any help would be greatly appreciated. At one point I thought it sounded like it was coming from the Extruder gear but not sure. I checked the Y-axis grub screws and they are tight. Forgive the bad videos.
Questa discussione è stata modificata 3 years fa da SC21
Postato : 03/06/2021 1:45 am
RE: New PRUSA Mini+ = Rattle sound cannot identify
I would recommend you contact support on the eShop Chat.
--------------------
Chuck H
3D Printer Review Blog
Postato : 03/06/2021 3:54 pm