Notifiche
Cancella tutti
My worst jam so far with the mini
I've had my Mini+ since November of 2020 and it's been printing flawlessly for the majority of that time. Today though, I had to deal with my worst nozzle jam which was caused by my PTFE tube shrinking in length. Couple pics below to show what I pulled out with a cold pull. Thankfully I have the replacement PTFE tube on hand but I am curious if there is a better / more permanenet solution? I do have a e3d v6 laying around from a past printer so I am tossing around the idea of installing that.
Old tube = 42.13mm
New tube = 43.52mm
Questa discussione è stata modificata 2 years fa 2 tempo da obv
Postato : 18/07/2022 6:19 pm