Clear all

MK3S screen not working  

Jim rRowland
Active Member
MK3S screen not working

I updated the firmware and when I went to use it the screen went blank. It lights up but nothing there. I talked to tech support and was sent the main board. I installed according to chapter 8-9 and when I turned it back on I had the same problem blank screen. This is going on 4weeks that I can’t print anything. I have replied to the original e-mail but haven’t heard back. I want to print but I can’t. 

Posted : 10/06/2020 11:10 pm
Roger Eberhart
Active Member
RE: MK3S screen not working

One forum down. You're in the Prusa Mini section.

Posted : 11/06/2020 5:24 am
Prominent Member
RE: MK3S screen not working

Any chance it is actually a bad display and not board? 

Posted : 11/06/2020 9:55 pm