Mini Crashes during mesh leveling.
Last night I updated my firmware on my mini to 4.2.1-final in anticipation of printing with it today. I'm managing my Mini with Octoprint 1.4.0 running on a Rapberry Pi 4.
Today I started a print job and during bed mesh leveling when it started point 1 on the back row, or point 13 overall, my Mini crashed with an M112, see photo:
I've reset the printer and verified the firmware. I made 3 attempts to get the print to start all 3 failed in the same place.
Where do I go from here?
Thanks
-Bob
Prusa I3 Mk2 kit upgraded to Mk2.5s, Ender3 with many mods, Prusa Mini kit with Bondtech heat break, Prusa I3 Mk3s+ kit
RE: Mini Crashes during mesh leveling.
Well, maybe you can learn from me.
This printer is in a dimly lit area and I didn't realize the build surface wasn't positioned correctly on the magnetic plate. I was going through diagnostics with it when I grabbed a flashlight to see better and discovered the plate was cocked a little and when the Minda probe moved to point 13 it was no longer over the build surface. I put the build surface back on correctly and everything is fine now.
-Bob
Prusa I3 Mk2 kit upgraded to Mk2.5s, Ender3 with many mods, Prusa Mini kit with Bondtech heat break, Prusa I3 Mk3s+ kit