Notifications
Clear all

Mesh bad leveling  

  RSS
Ardumet_cz
(@ardumet_cz)
Active Member
Mesh bad leveling

I use the default settings in PrusaSlicer for MINI+. It was leveled before printing, but during the first layer it seems to me as if the bad leveling did not project directly into the print, as if the printer did not recalculate the data obtained from the superpind.

Start Gcode:

M862.3 P "[printer_model]" ; printer model check
G90 ; use absolute coordinates
M83 ; extruder relative mode
M104 S170 ; set extruder temp for bed leveling
M140 S[first_layer_bed_temperature] ; set bed temp
M109 R170 ; wait for bed leveling temp
M190 S[first_layer_bed_temperature] ; wait for bed temp
M204 T1250 ; set travel acceleration
G28 ; home all without mesh bed level
G29 ; mesh bed leveling 
M204 T[machine_max_acceleration_travel] ; restore travel acceleration
M104 S[first_layer_temperature] ; set extruder temp
G92 E0
G1 Y-2 X179 F2400
G1 Z3 F720
M109 S[first_layer_temperature] ; wait for extruder temp

; intro line
G1 X170 F1000
G1 Z0.2 F720
G1 X110 E8 F900
G1 X40 E10 F700
G92 E0

M221 S95 ; set flow
Posted : 27/05/2023 6:24 pm
Share: