[Risolto] Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.  

RE:

Yeah I used some a few months ago but it was in kinda bad conditions so I figured it was no good, and it printed terrible, much like this time.
I used some when I first got it and it was ok but it had a lot of inconsistency, sometimes it bubbled sometimes under extruded.

Now that I think about it, never had a really quality print with Hatchbox, which is weird because I've seen Prusas use it just fine before.

I will have to try the oven trick.
I will give the calibration one more shot with the Hatchbox.

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

yeah try the oven trick i use esun pla+ i find that stuff really good

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

glad that your printer is up and running and after 4 pages we came down to a soulution

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

cool I will have to look into that. Should I try the oven trick before doing another first layer? Currently running the cube test print.

RE:

honestly lol

was a great learning experience though, a ton of new troubleshooting steps that I had never done so at least there was some learning.

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

do the oven trick first 5 miniuits no less no more then do first layer and let me know how it goes yes sorry if some of it seemed confuising

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

Will do. No problem, I appreciate the help.

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

all good the if the oven trick dosent work then heat printer to 260 degress run the fillament through a bit then col down printer to 220 and try print

RE:

ok, also is that oven trick in Celsius (80c)

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

yes

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

American oven moment lol

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

hahaha lol 

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

don leve it in too long only enough to draw out the humity

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

Yeah I ran it through the oven, ill test in a minute when the box is finished.

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

👍 

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

Sides/bottom are good, top is a little funky not entirely sure why

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

that is not right

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

what was your tmp at

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

215c

could try running it at 220c

RE: Having trouble with print quality (under-extrusion) after printing with relatively no problem for a year or so.

i mean temperature