Notifications
Clear all

Bondtech drive for mini+ and saving to eeprom  

  RSS
Feles Mala
(@feles-mala)
New Member
Bondtech drive for mini+ and saving to eeprom

I bought the bondtech dual drive upgrade when I ordered my mini, but I'm holding off until the mini firmware supports saving the steps/mm setting to eeprom. Apparently this has been a known bug for some time.

Does anyone know if/when this will happen?

 

🙂

Posted : 11/01/2021 7:55 pm
mrstoned
(@mrstoned)
Reputable Member
RE: Bondtech drive for mini+ and saving to eeprom

I believe that is permanent changed from 4.0.5 firmware.

Esteps can be set in slicers start code.

Prusa Mini+ kit. BondTech extruder. FW 5.1.2
Prusa MK3S+ kit. Stock. FW 3.11.0
Prusa MK3S+, used. Stock. FW 3.13.3

Posted : 11/01/2021 11:21 pm
handro
(@handro)
New Member
RE: Bondtech drive for mini+ and saving to eeprom

Best is to subscribe for updates here: https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/767

Posted : 12/01/2021 12:05 am
Pinkie Pie
(@pinkie-pie)
Eminent Member
RE: Bondtech drive for mini+ and saving to eeprom

Just add a start gcode to filament and printer gcode.

Why filament? As a small "failsafe" , once my slicer defaulted to stock settings and it took me a day to figure underextrusion problems.

Posted : 12/01/2021 12:05 am
Share: