Notifications
Clear all
Black blob midprint, gunk on hotend
Hi,
Something happend during my last print while I was absent. Can someone point out what could have caused this and if it's possible to prevent it?
I came back to my print and the hotend looking like seen on the pictures below. The print obviously finished and the hotend was clean before I started the print.
Posted : 23/09/2022 12:13 pm
RE: Black blob midprint, gunk on hotend
I need more information. Which end of the print is the Gash on? Maybe a wider image of the print.
--------------------
Chuck H
3D Printer Review Blog
Posted : 24/09/2022 12:12 pm
Topic starter
answered:
RE: Black blob midprint, gunk on hotend
Just realized the lack of info, sorry. The print is roughly 13cm in height and took almost 10 hours, had a good amount of support. The material was Prusa PETG. The mishap occurred around 1cm below the top.
Posted : 24/09/2022 11:42 pm