Where do I ask Prusa about adding a feature to the printer software?
 
Notifications
Clear all

Where do I ask Prusa about adding a feature to the printer software?  

  RSS
chris_launer@yahoo.com
(@chris_launeryahoo-com)
New Member
Where do I ask Prusa about adding a feature to the printer software?

I have a question.  If I would like Prusa to consider a feature to be added to the printers software they sell or how to add it to mine; how do I do that? 

When I go to change filament, I walk away from the printer to let it warm up.  Would it be difficult to add a alarm to the printer that could be shut off if the user wanted, to signal it is at the temp to change filament?  I forget the head is hot, and it stays that way until I remember to go and change filament.  I wish it would notify me when it is at filament changing temp.  

Thanks.

Napsal : 25/05/2021 11:31 pm
Lichtjaeger
(@lichtjaeger)
Noble Member
RE: Where do I ask Prusa about adding a feature to the printer software?

Github.

Napsal : 26/05/2021 5:50 am
Neophyl
(@neophyl)
Illustrious Member
RE: Where do I ask Prusa about adding a feature to the printer software?

Yes github for all the prusa projects in the correct places for the product the request relates to.  However at the moment Prusa are soliciting suggestions foir the 8bit board that runs the Mk3 series of printers in this thread on the forum - https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/what-would-you-like-to-see-in-the-8-bit-firmware-2/

Also your request has already been made https://github.com/prusa3d/Prusa-Firmware/issues/697   

 

Napsal : 26/05/2021 6:04 am
Share: