Notifications
Clear all

PrusaLink Features Requests  

  RSS
KOBALT3D
(@kobalt3d)
Eminent Member
PrusaLink Features Requests

It would be nice to have these features implemented in PrusaLink:

  • firmware updater for MK3 and other supported models. Manual or automatic (download and update firmware for detected printer)
  • upload or copy/move gcode to printer's SD card from PrusaLink storage
Opublikowany : 03/04/2023 7:10 pm
Ty polubić
Tojik
(@tojik)
Member Moderator
RE: PrusaLink Features Requests

Hi. both of these are not going to happen
Moving anything to the SD card would be slow. 11kB/s at best, slow. A 6MB file would take at least 10 minutes.
Firmware updater is not worthwhile investment. It would work only over USB, or would require a bootloader update which we never have done on the MK3 and if it would fail, the printer would be bricked and require manual flashing to get fixed.

Opublikowany : 04/04/2023 2:01 pm
Share: