Notifications
Clear all
New feature request set a start print schedule (range)
I have just started using Prusa Connect at my work, and I am loving the queue system. I can drop all my prints in the queue, duplicate them properly, and not worry about over- or under-printing the quantities. The Issue is that the estimated Print ending time is always wrong because I can not start a print at 1:00 or 2:00 am. Since I am sometimes setting up 10-15 prints at a time, setting each print to a schedule is terrible. If we could set a time range, say 7:00 am-4:00 pm Mon-Fri, Connect will push the start time estimate until it is within that range. I think the print end estimate would be much better, and all of us could plan out the schedule better. Any thoughts? Does this already exist somewhere, and I missed it?
Posted : 02/04/2026 2:27 pm