Benachrichtigungen
Alles löschen
Y Axis Text Failed
My MINI+ has been printing fine! Then I just upgraded to firmware to 6.0.4. After installation the new firmware started running all of these new tests. Everything was going fine until the Y Axis test. The test failed on I believe the last Y axis pass. Of course there are NO instructions anywhere on what to do to rectify this problem.
Veröffentlicht : 25/07/2024 9:03 pm
RE: Y Axis Text Failed
Did you ever find a solution.. same issue here
Veröffentlicht : 05/11/2024 5:59 pm