Notifications
Clear all
PSA: Don't try to push stuck filament in PTFE tube with another filament
...because the stuck filament might push the new one on the side of the PTFE tube and penetrate it.
So don't be dumb/lazy like me, and unscrew the tube and remove it by hand. 👍
Napsal : 29/09/2020 9:39 pm
RE: PSA: Don't try to push stuck filament in PTFE tube with another filamentjbjhk
That is bed luck. I do this all the time without issue. I even use a tungsten rod.
--------------------
Chuck H
3D Printer Review Blog
Napsal : 29/09/2020 10:04 pm