Prusa mini users prints gallery ?  

RE: Prusa mini users prints gallery ?

Direct comparison.  One is from the MK3s the other is from the mini.  Same filament, both sliced in PrusaSlicer with the same parameters and auto generated support.

It is a difficult model which at this smaller size causes all my printers a bit of trouble but the Prusa's do the best job.  On the whole, they are pretty similar.  If I had to choose though, I would choose the one on the right.

The Mk3s in the one on the left and the mini is on the right.

RE: Prusa mini users prints gallery ?

Can you link to the STL or save & zip the 3MF project file for this piece? Looks like an interesting challenge.

RE: Prusa mini users prints gallery ?

@bobstro

Well even at this size which is around 9cm diameter, it takes around seven hours to print as there is a fair bit of support required (The last full size one I printed took over five days 🙁 ).  I have just posted this on thingiverse as you showed a bit of interest.  However, it is a part of a larger model which I sell as a limited edition item so I can't make the model public domain as I usually do.  It is here if you want it and if you manage to find a better profile for printing this I'd be happy to hear of it 🙂

https://www.thingiverse.com/thing:4174988

RE: Prusa mini users prints gallery ?

Posted by: @mark-g33

Well even at this size which is around 9cm diameter, it takes around seven hours to print as there is a fair bit of support required (The last full size one I printed took over five days 🙁 ).  I have just posted this on thingiverse as you showed a bit of interest. 

Thanks for sharing the part. I like to experiment with printing challenges. This one definitely pushes the envelope!

RE: Prusa mini users prints gallery ?

I've been very impressed with the quality. Not sure the photos does it justice.