Notifications
Clear all

Prusa mini print log access  

  RSS
SEDAudio
(@sedaudio)
Active Member
Prusa mini print log access

Good morning, 
I have come to my Prusa Mini+ this morning, which I left printing some spare parts parts for the printer, to find that it has come to the end of printing without finishing the prints. The screen was showing the usual dialog when the print ends, but the print clearly isn't complete. 
There was a small blob of filament on top of one part, like you get when the thing sits with the hot end running for some time and the remaining plastic runs out of the nozzle.
Is there a way to access and kind of print log history, perhaps by SSH or USB/UART access?

Many thanks

Posted : 08/07/2021 7:48 am
SEDAudio
(@sedaudio)
Active Member
Topic starter answered:
RE: Prusa mini print log access

Sorry, I thought I had put this thread in another Prusa Mini subchannel. 
Not sure how to move it.

Posted : 08/07/2021 11:01 am
Joe
 Joe
(@joe-11)
New Member
RE: Prusa mini print log access

Did you ever figure anything out for this issue? I just experienced this as well. appears as if print was finished as expected but really stopped about 20% into the job. 

Posted by: @sedaudio

Good morning, 
I have come to my Prusa Mini+ this morning, which I left printing some spare parts parts for the printer, to find that it has come to the end of printing without finishing the prints. The screen was showing the usual dialog when the print ends, but the print clearly isn't complete. 
There was a small blob of filament on top of one part, like you get when the thing sits with the hot end running for some time and the remaining plastic runs out of the nozzle.
Is there a way to access and kind of print log history, perhaps by SSH or USB/UART access?

Many thanks

 

Posted : 24/11/2022 12:35 pm
SEDAudio
(@sedaudio)
Active Member
Topic starter answered:
RE: Prusa mini print log access

It was quite some time ago now, but no, I don't think I nailed it down exactly.
Pretty sure I ended up replacing my USB stick with a much better one, and I haven't experienced this problem again since.

Posted : 24/11/2022 12:55 pm
Joe
 Joe
(@joe-11)
New Member
RE: Prusa mini print log access

 

Posted by: @sedaudio

It was quite some time ago now, but no, I don't think I nailed it down exactly.
Pretty sure I ended up replacing my USB stick with a much better one, and I haven't experienced this problem again since.

Okay, thanks. I'll try that if it happens again. 

Posted : 24/11/2022 1:39 pm
Share: