First layer has 'spots', but the print is amazing, and the bottom looks great too
My first layer of a print does these weird spots in some areas. The bottom of the print looks great, but Id like to get this fixed up. Z calibration looks awesome in the same spot, so thats whats confusing me.
Second layer covers this and everything is awesome from there on out. So Im at a bit of a loss. Anyone?
Best Answer by JoanTabb:
looks like LiveZ is a little low.
the rippling, is filament being pushed out of the way by new filament.
you need a smaller negative number for live Z
regards Joan
RE: First layer has 'spots', but the print is amazing, and the bottom looks great too
looks like LiveZ is a little low.
the rippling, is filament being pushed out of the way by new filament.
you need a smaller negative number for live Z
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: First layer has 'spots', but the print is amazing, and the bottom looks great too
Waves are a tell tale sign of live z being too low. If it's only on one side, left or right, it could indicate a tilted print bed. Google for Prusa mini xz skew.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
RE: First layer has 'spots', but the print is amazing, and the bottom looks great too
Yup, thats what it was. Many thanks!