Firmware 5 - Experimental
Hello everyone,
I'm trying to add the bondtech e-steps value and reverse extruder direction as per step 30 in the guide
https://support.bondtech.se/Guide/01.%20Feeder%20Upgrade%20Kit/59.html
Sadly I can't find the setting within firmware 5.1.2
Any help welcome
Best Answer by strugo:
You must long-press the knob when you're in the hardware setting menu. Enjoy your bondtech extruder upgrade, it's really an improvement.
Prusa MK4 | VanillaPrusa Mini | BondTech Extruder | BondTech Heatbrake | Supper PINDAEnder 3 Pro | Micro Swiss Direct Drive and Hotend | WamBam Bed
RE: Firmware 5 - Experimental
You must long-press the knob when you're in the hardware setting menu. Enjoy your bondtech extruder upgrade, it's really an improvement.
RE: Firmware 5 - Experimental
Thank you very much appreciated
Prusa MK4 | VanillaPrusa Mini | BondTech Extruder | BondTech Heatbrake | Supper PINDAEnder 3 Pro | Micro Swiss Direct Drive and Hotend | WamBam Bed
RE: Firmware 5 - Experimental
Oh my, encountering issues with the new settings, haha... When I load the filament, it seems to load but then reverses unexpectedly.
Prusa MK4 | VanillaPrusa Mini | BondTech Extruder | BondTech Heatbrake | Supper PINDAEnder 3 Pro | Micro Swiss Direct Drive and Hotend | WamBam Bed
RE:
Setting the Extruder dir back to Prusa seems to have fixed it ...
Prusa MK4 | VanillaPrusa Mini | BondTech Extruder | BondTech Heatbrake | Supper PINDAEnder 3 Pro | Micro Swiss Direct Drive and Hotend | WamBam Bed