Vase mode issue
Hello and best wishes My issue is the following.
I print planes in pla lw and they are now optimized for printing in vase mode.
So far everything is going well and it works, no visible connections, cohesion of the thread and reduced printing time. In addition, with the lw pla, no twists remain inside the wing section. My question concerns precisely these wing sections. We therefore have one or two lower solid layers and the mode vase up to the top.
For my own reasons (solidity of the assembly among others), I would like to close the top with one or two solid layers, but the vase mode prohibits me from doing so. I tried with range modifiers without result, I tried to cut the piece on the last two layers but that doesn't work either or I'm doing it wrong (possibly)
The fashionable vase seems to fit the whole room with no exception possible?!
If a kind soul can tip me off on how this is possible. I specify that the solid model is well closed on each side before cutting
Thanks in advance