Notifiche
Cancella tutti
Colorfabb allPHA
Hi,
So I tried to print with PHA, but I think the only thing I managed is to get my bed dirty and not sure how to clean it up.
So loaded the filament just fine, but then when I started printing it stopped extruding almost right away so not sure what happened here ( keep in mind I am a beginner). I used the slicer's setting for the allPHA and a smooth sheet with lac as I know it warps a lot. What it did extrude, I cannot get off the bed it's just a smug of plastic now.
So two questions :
How to clean my bed?
How to print allPHA?
Postato : 10/05/2026 9:19 am