Help Please. What would cause this?

Dernier message

RSS

Kyle Alford

(@kyle-alford)

Membre

Help Please. What would cause this?

Publié : 15/06/2025 4:50 pm

(@6)

Membre

RE: Help Please. What would cause this?

Try reducing layer height.

Publié : 25/06/2025 9:10 pm

UjinDesign

(@ujindesign)

Estimable Member

RE: Help Please. What would cause this?

It's only happening in the corners / curves, so it might be a pressure advance problem. I have no idea how to solve it if it is a pressure advance problem though.

Publié : 26/06/2025 6:48 pm

Statistiques du forum

585 Forums

68 K Sujets

476.8 K Messages

9 En-ligne

75.7 K Membres

Le dernier des messages: Feeding issue Notre nouveau membre: Tommy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé