Notifications
Clear all
Filiment Change sensor triggering
So, I am having issues printing (duh) and I can't quite figure out what is going on. When I print, it randomy stops, like I put a change filament stop in the gcode but I didn't. This is happening for all prints. I tried a few cold pulls, cleaning the nozzle, reconfiguring the filament sensor, and even tooling a bit with the tightening of the springs on the feed tube. I am out of idea. Has anyone else had this happen? Any ideas? I am hoping its not a short.
Posted : 21/04/2026 7:51 pm
RE: Filiment Change sensor triggering
Carefully clean and recalibrate the filament sensor.
Posted : 22/04/2026 2:02 pm
Topic starter
answered:
RE: Filiment Change sensor triggering
I jsut realized this was put under the MK4 S forum, I am closing this and reopening it in the correct Forum. Thank you
Posted : 22/04/2026 10:15 pm