Prusa Connect Firewall rules

Dernier message

RSS

Tom Stein, ETH...

(@tom-stein-ethz)

Membre

Prusa Connect Firewall rules

Hello everyone,

does anyone know which firewall rules are required for the MK4S to connect to Prusa Connect cloud? Which ports, protocols and addresses are required for the communication from the printer to the cloud?

I assume it is mqtt or https traffic.

Thanks
Tom

Publié : 23/08/2024 9:46 am

FoxRun3D

(@foxrun3d)

Famed Member

RE:

I didn't have to configure anything on the router so I assume it's just http(s) traffic

Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...

Publié : 24/08/2024 12:18 am

Tom Stein, ETH...

(@tom-stein-ethz)

Membre

Topic starter answered:

RE: Prusa Connect Firewall rules

Same, it works for me with the default settings. However, I would like to whitelist the prusa connect traffic in my firewall and block everything else.

Publié : 24/08/2024 8:41 am

Statistiques du forum

559 Forums

63.1 K Sujets

443.8 K Messages

20 En-ligne

68 K Membres

Le dernier des messages: Too much part cooling after upgrade from mk4 to mk4s? Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé