Notifiche
Cancella tutti
Filament Change with MMU3 takes five minutes
Normal wipe tower operation up until the point where it should retract the filament. At that point it just cycles back and forth like it is wiping, but no filament is extruded. After about five minutes of this, it retracts the filament and makes the change. Next filament change results in the same cycle.
All kind of funny when I got an email telling me how fast the new firmware would change filaments.
Filament: PCTG - 3D Fuel
When I get a chance, I'll try the same model with PLA to see if that is connected.
Postato : 17/04/2026 12:09 pm
1 persone hanno apprezzato