Notifications
Clear all
Mk4s keeps asking to change filament for no reason
Hi,
My Mk4s keeps asking to change filament for no reason. The most recent case of this https://www.prusaprinters.org/prints/13490-prusa-i3-mk3s-black-psu-replacement-frame-brace-wi.
I´m using the latest slicer and firmware and made sure there are no changes in the file before slicing and the printer reports no changes.
Any ideas?
Opublikowany : 06/11/2024 1:48 pm
RE:
Could your filament sensor be stuck?
There is a small hole on top of the extruder. You can blow air in there to clear any possible debris.
This post was modified 4 hours temu by Brian
Opublikowany : 06/11/2024 4:26 pm