Notifications
Clear all

MK4S HF Nozzle is Input Shapping Used or Not?  

  RSS
printythings
(@printythings)
Member
MK4S HF Nozzle is Input Shapping Used or Not?

Upgraded to the MK4S and noticed some ghosting issues I didn't remember having before.  Thought it was due to the default input shaping profile, so used the new accelerometer to tune to my specific setup, but it made little difference.  But then I started to notice that the new MK4S profiles don't mention input shaping.  Is it just enabled by default in firmware now and doesn't need a specific slicer profile?  

Referencing this KB here https://help.prusa3d.com/article/input-shaper-mk4-s-mk3-9-s-mk3-5-s-xl-mini_451816

Posted : 11/12/2024 3:40 pm
Share: