Notifications
Clear all
First problem after MK4S upgrade
After upgrading my MK4 I've had great prints and no more layer shifts. Yesterday I had my first issue. After about 30 minutes into print (using PETG) the print stopped and I got some sort of message (I don't remember the exact words) telling me the filament wasn't moving the way is should be. I following the instructions to unload then reload and everything seems good. I noticed on a large flat portion of the print there were a few globs of filament that had appeared. I watched the extruder the next time it went over those areas and didn't see any issues. Later, when I came bake to the print I had massive stringing. What would cause this?
Publié : 04/11/2024 9:32 am