Getting Filament Warts in only Certain Areas of Print (MK3S+ to MK4S Upgrade)
Hello:
I printed the following rocket engine : https://www.printables.com/model/436722-rocket-engine-mk4
Here are the photos (full res): https://imgur.com/a/WZGs2tS
Using input shaping on my newly upgraded MK3S+ to MK4S printer. Everything looks great except for the circles portions on the attached photos.
The circle areas almost look like wart photos I have seen on these forums for very wet filament, however I would think that the warts would be throughout the print, not just on certain faces (see photos).
I also noticed a layer shift near the top of the print, I read alot of comments for the model saying they had that too, not sure if its a problem with my printer or what.
Any help would be greatly apprciated on how to get rid of these ugly warts. Also the seams were painted on the .3mf file i downloaded, and the are aligned on the black portion, so I dont think it is a seam setting going on here.
