Notifications
Clear all
Bed Temp? Creality PLA
I had stringing did temp tower, seemed around 200 was good. I think this had 210 first layer 200 rest and 60 bed maybe 70 first layer? It just keeps catching on printed layers and I hear a scraping sound and have a mess to clean up. Does anyone have good temps for Creality PLA? Thanks 🙂
Posted : 28/04/2025 12:09 am
Topic starter
answered:
RE: Bed Temp? Creality PLA
I was trying to get the peeled circle bottom left off incase it could keep printing at slower speed over it but it was stuck to the other part that's why a bit is lifted there
Posted : 28/04/2025 12:12 am
Topic starter
answered:
RE: Bed Temp? Creality PLA
This was 190C 60C still doing it straight away going to try higher bed lower nozzle
Posted : 29/04/2025 1:28 am
Topic starter
answered:
RE: Bed Temp? Creality PLA
180 and 70, way worse, try the other way maybe
Posted : 29/04/2025 1:30 am
Topic starter
answered:
RE: Bed Temp? Creality PLA
190 50 and 50% speed, so close... might try 180 i think speed is a factor
Posted : 29/04/2025 1:36 am