Notifiche
Cancella tutti
Layer lines and marks where the printhead starts the turn
I have two issues in my current print.
First, I have very obvious layer lines and second, at the position where the printer starts and ends the outer wall there is an obvious mark. It looks like there is too much material an this spot.
Could it be some overextrusion? Should I change some parameters in the filament settings or print settings?
It's printed with R3D PLA+ Light Skin, at 205 °C
PrusaSclicer 2.8.1, Prusa MK4 Firmware: 6.1.3+7898
Thank you very much for any ideas
Postato : 07/11/2024 11:32 am