Notifiche
Cancella tutti
.4 Obxidian nozzle printing issue vs stock .4 nozzle
Hi, I’m hoping someone can point me in the right direction here what might be causing this issue.
I recently changed out my .4 stock nozzle for the Obxidian .4 nozzle and I noticed some printing issues next to the vertical walls. I tried to fix it by raising the temps on the print and that didn’t seem to fix it.
Same filament (Prusa PET-G), same bgcode, latest firmware as of 6/5. I switched back to the stock nozzle and the issue went away.
Any thoughts on what to try next?
Thanks for the help.
Postato : 06/06/2024 5:53 pm
Wayne hanno apprezzato