Notifications
Clear all
Z-calibration always on same points: damage to print sheet
I have a PEI sheet that was one flat but now begins to show damage on the points where the z-calibration is done. I use that sheet to print PC on, A smear of glue and it works like a charm, but for the PC the nozzle is pretty hot and I begin to see damage at the probing points. I started now to place the sheet a few mm off the 'official' position to reduce the marking. It works, but it does not win a prize.
Is there a way to in the firmware or in the slicer move or 'randomize' the probing points?
Posted : 27/06/2025 8:44 pm