Notifications
Clear all
Remaining Time, Estimated End Time, Running Time, Image Preview not displaying
I've never gotten any of the above except for when I ran a gcode specificly downloaded from printables for a temp tower test. I'm having difficulty understanding how to enable them. The only thing it does show is the estimated time that the print should take. If anyone can help me figure this out, would appreciate the help.
Publié : 13/09/2024 2:53 am
Topic starter
answered:
RE: Remaining Time, Estimated End Time, Running Time, Image Preview not displaying
nm, finally found it
Publié : 13/09/2024 6:26 pm