Preview image confused me - no brim.

Dernier message

RSS

Tom Horsley

(@tom-horsley)

Trusted Member

Preview image confused me - no brim.

I thought I had sent the wrong file to the printer when I saw the preview the printer firmware drew in the LCD. I sliced it with a brim, but there was no sign of a brim in the preview. Does it just ignore rendering the gcode where it is only 1 layer thick or something?

Publié : 13/10/2023 11:32 pm

kUMters

(@kumters)

Estimable Member

RE: Preview image confused me - no brim.

Exported preview pictures doesn't contains brim/supports/raft...

MK3S + MMU2S (@BMG + MOSQUITO), MINI, ANET A8

Publié : 14/10/2023 10:34 am

Statistiques du forum

559 Forums

62.9 K Sujets

443.1 K Messages

21 En-ligne

67.7 K Membres

Le dernier des messages: Prusa MK4S & MMU3 vs Bambulab A1 & AMS Lite Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé