Avisos
Vaciar todo
MK4 & MK3.9 - Printing Issue
Both on Firmware 5.1.3
I keep getting a ripple like pattern on my prints. It happens after the first layer and at the first layer, sometimes. See photo. I have an MK3.9 and MK4 and it is happening on both printers.
Using Prusa Slicer 2.74. | Using PLA AMOLEN
Printing PLA, adjust temperature up and down.
Not sure what the cause is thus far but happens on BOTH printers.
Filament new and dry.
Even bought a filament drier.
User different filaments
Both Beds have been cleaned & washed; swapped out another bed.
Nozzle isn’t clogged at all, even changed both nozzles.
I re-calibrate the printer.
Este debate ha sido modificado el hace 7 months por Hawkfyre
Respondido : 17/04/2024 1:37 am