Notifications
Clear all

MK4 & MK3.9 - Printing Issue  

  RSS
Hawkfyre
(@hawkfyre)
Member
MK4 & MK3.9 - Printing Issue

Both on Firmware 5.1.3

 

I keep getting a ripple like pattern on my prints.  It happens after the first layer and at the first layer, sometimes.  See photo.   I have an MK3.9 and MK4 and it is happening on both printers.

Using Prusa Slicer 2.74. | Using PLA AMOLEN 

Printing PLA, adjust temperature up and down.

Not sure what the cause is thus far but happens on BOTH printers.

Filament new and dry.

Even bought a filament drier.

User different filaments

Both Beds have been cleaned & washed; swapped out another bed.

Nozzle isn’t clogged at all, even changed both nozzles.

I re-calibrate the printer.

 

 

This topic was modified 8 months ago by Hawkfyre
Posted : 17/04/2024 1:37 am
Share: