Notifiche
Cancella tutti

Gaps in Top Layer  

  RSS
cory.w
(@cory-w)
Estimable Member
Gaps in Top Layer

I consistently have gaps in my solid layers as they go past the 2nd layer or so. I already calibrated the flow and seems perfect. Using pretty standard settings for Prusa PLA even though i'm using Polymaker Matte filament (this is why I adjusted flow). Even with ironing it has a bit of gaps.

Advise? I was going to increase flow more but the first layer is nearly perfect besides a small gap thats always on one side of the infill lines and the perimeter but this has always been the case with basically every prusa printer I have.

 

Postato : 04/07/2024 8:06 pm
Condividi: