Notifications
Clear all
Filament sensor Issue
So, I am having issues (duh) and I can't quite figure out what is going on. HELP! When I print anything, it randomy stops, like I had put a change filament stop in the gcode but I haven't. This is happening for all prints.
I have tried a reflashing the software, a few cold pulls, cleaning the nozzle, reconfiguring the filament sensor, reconfiguring the gear box, blowing air into the hole ontop of the gearbox while moving filament in and out, and even tooling a bit with the tightening of the springs on the feed tube. I am out of ideas. Would a Factory reset help at all?
Has anyone else had this happen? Any ideas? I am hoping its not a short in the filament sensor.
Posted : 22/04/2026 10:19 pm