Cracking in a certain place when the extruder moves to the side

Dernier message

RSS

Kentril

(@kentril)

Membre

Cracking in a certain place when the extruder moves to the side

Hello, I have MK4 and sometimes have a problem; when the extruder moves to the side, sometimes you can hear such a popping sound. What should it cause? I think I have a similar problem too.

https://forum.prusa3d.com/forum/original-prusa-i3-mk3-czech-cesky-slozeni-tiskarny-a-reseni-potizi-s-prvnim-tiskem/praskani-v-urcitem-miste-pri-prejezdu-extruderu-do-strany/

Thanks for advice

Regards Jiri

Publié : 10/10/2024 6:41 am

Kentril

(@kentril)

Membre

Topic starter answered:

RE: Cracking in a certain place when the extruder moves to the side

Posílám ještě video:

VID_20241010_095653.mp4

Publié : 10/10/2024 8:05 am

Statistiques du forum

565 Forums

63.4 K Sujets

445.6 K Messages

21 En-ligne

68.6 K Membres

Le dernier des messages: Extruder not working on 2nd layer and up for tool head one Notre nouveau membre: Frickelfred Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé