Notifications
Clear all
Bed Leveling issue
I'm having a bed leveling issue with my MK4. The rear left quadrant of the bed is not being leveled properly. I've tried cleaning the nozzle and ensured there is nothing under the bed.
It is consistent from every print. The attached phot shows the brim from a recently printed part. You can see that one quadrant of the brim is threads as opposed to a consistent layer in the other quadrants.
Running version 5.1.2*13478.
Any ideas what would cause this?
Any ideas?
Napsal : 28/12/2023 6:50 pm