Anyone getting unwanted extrusion on heat up/print finish?
 
Avisos
Vaciar todo

Anyone getting unwanted extrusion on heat up/print finish?  

  RSS
Lordran_Hollow
(@lordran_hollow)
Active Member
Anyone getting unwanted extrusion on heat up/print finish?

This just popped up on the last two prints, but the Nextruder has started purging filament whenever it heats up or immediately after a project. It'll sometimes purge up to 2-3".

 

For reference, I'm running PETG from MatterHackers and using the Generic PETG profile in PrusaSlicer while also running the InputShaper 5.0.0 RC Alpha.

Respondido : 27/08/2023 1:43 am
Compartir: