Notifications
Clear all
Suppress new firmware notice?
I just did a "upload and print" from Prusa Slicer, confident that it would work as it always has and didn't check on the printer for 5 or 10 minutes. When I did check, it had been sitting there with a "new firmware" notice on the display doing nothing. Grr! Aargh! Is there a setting to suppress these new firmware checks so this won't happen again? I'm perfectly capable of noticing new firmware announcements here and manually downloading it :-).
Opublikowany : 10/11/2023 8:17 pm
Topic starter
answered:
RE: Suppress new firmware notice?
I think I found it. The slicer is generating it via an M115 it puts in the startup code. I've modified the startup code so maybe my next print won't annoy me so much.
Opublikowany : 10/11/2023 10:07 pm