Avisos
Vaciar todo
Support Cubic not printing perimeter?
First time using support cubic. I've got 3 parameters so I don't really need that much infill on this model, but I'm getting this weird issue where the print doesn't seem to do the perimeter layers when it gets to the infill bit... not all the infills though, the ones higher up are fine.... Anyone familiar with this and what I'm doing wrong? ty!
Este debate ha sido modificado el hace 10 months por RyCoFX
Respondido : 19/01/2024 4:49 pm
Topic starter
answered:
RE: Support Cubic not printing perimeter?
Hm... if I use the clip geo feature and clip out only that issue section of the geo it prints fine.
Respondido : 19/01/2024 5:19 pm